What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 28.06.2025 06:27
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This one hit behind the barn.
First Sentence:
Global Investors Suddenly Have a New Concern: A U.S. ‘Revenge Tax’ - WSJ
but this device (an Inductor) … impedes the rapid changes in the current.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Upvotes:
McDonald's shares slip after downgrade spurred by weight-loss drug popularity - CBS News
The MOV will conduct when the voltage exceeds 50% of line voltage.
[image of Common-mode choke]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Bonnaroo 2025 Canceled After Rains Swamp Festival Grounds - Rolling Stone
The third is lightning and “how it gets conducted into a home.”
Edit 2024–10.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
China Auto Body Slams ‘Vicious Competition’ After BYD Price Cuts - Bloomberg
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
So, the voltage could go up to 500 volts, and the fuse will not open up.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
a photo is worth a thousand words.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
What are some disadvantages of living in rural areas? What are the advantages?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
so, what happens?
This is where the MOV conducts again, and dissipated the energy.
But it can get overloaded, and no longer works.
He then describes Rainy Season and Lightning.
A fuse is a non-resetable over current circuit protector.
Because the load is inductive, the current lags the voltage.(by a bit).
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but I think this circuit , shows a few more pieces.
Maybe not best, but Sounders are most fitting MLS Club World Cup representative - Sounder at Heart
The bolt then partially travels down the line to your home.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Can bosses get fired for being too hard on employees?
2024–10–14 [Omar Gharbi Omar Gharbi ]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
But… the neutral is now “floating” because of the 1 ohm resistance.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
A circuit breaker is similar, but is resettable.
He then describes the function of a fuse.
An AC voltage/ current source, and an ac inductive load.
Here is a simplified AC power diagram.
what exactly is a ‘surge’ protector?
At one ohm, the resistor has a maximum of 1 watt power.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The other is “what does a “fuse” do?”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–10[John johnson John Johnson ]
He then asserts :
Now when you have a certain ac resistance, then a current flows in a loop.
This is where this question deviates from being a 'generic' question, and becomes more specific.
There are two important concepts here.
eight
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
These devices are installed between the “hot” and “neutral” and protective ground.
At least they know the answer if they wanted it.
[old diagram got deleted by accident]
There are three different concepts here that are getting confused.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Barnstars:
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
I post the exact comment here.
What is lightning?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This device then solves the entire problem.
This is 'the assistant's answer'
What does a fuse do?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
One
One is “what exactly is in a ‘surge protector’ ? ”
the problem then depends on "how fast does the fuse operate?".
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
For this case there are devices called Metal oxide varistors (MOV).
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
In schematic diagrams this is the symbol for a fuse:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
It also is a device that limits the change in current flow.
nine
(Dc diagram shown, AC is similar).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It seems Mohan does not understand the difference between a comment and an Answer.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.